The TZ-V-4DX is a quad-band trapped vertical antenna designed to permit operation on the low bands of 20/30/40/80m. As standard the antenna is designed for the 4 DX bands. If you've got a tight budget or a small yard or terrace house, why not give the usual HF DX frequencies a shot with a vertical. When mounted in the clear with a good number of quarter wave radials or longer the antenna will provide outstanding DX signals due to the low angle of radiation.
The TZ-V-4DX uses 3 coaxial traps which are not affected by rain since the traps are sealed. The TZ-V-4DX can be mounted in one of three (3) ways:
- Mount the antenna on the ground using a 50mm diameter galvanised steel pipe, 1000mm long or greater. Use a sledge hammer to insert the pipe into the ground or dig a hole and bury it so that approximately 300m protrudes above ground. Directly mount the vertical to the pipe. It is advisable to install a 2.0m or greater length of copper clad steel earthing bar next to the antenna to provide an adequate earth. Connect as many earth radials as possible for optimum low angle radiation and efficiency of your antenna.
- Mount the antenna on a metal deck roof (your garage for instance) and use the metallic structure as the ground plane for the antenna. Again a 50mm diameter pipe is recommended and the metal structure should have at least 1m2 of metal surface area.
- NOTE - NOT RECOMMENDED DUE TO THE PHYSICAL SIZE OF THIS ANTENNA. Mount the antenna on a mast or tower at any height and use a set of radials as the ground plane for the antenna. This is the most efficient method of mounting providing the best radiation pattern. RippleTech Electronics offers a set of three radials to suit the antenna for $66.00 inclusive of GST. For optimum VSWR the radials should be angled towards at an angle of approximately 45 degrees. The RippleTech radials are specially trimmed so that the antenna remains resonant for any of the three (3) mounting options.
Acetal plastic insulating sections are used for mechanical strength and stiffness so that the antenna can handle strong winds. The lower section of the antenna is 32mm O.D, tapering down to 10mm O.D. at the top. Trap covers are provided for bird and rodent protection rather than weather protection since the traps are fully sealed. The coaxial traps provide excellent isolation from band to band and their high Q ensures low losses. The bandwidth of the antenna is remarkable for a trapped antenna and the complete bandwidth of each bands is covered with VSWR under 2.0:1 when correctly tuned.
Stainless steel fasteners are used (except for mounting U bolts which are optionally S/S) as well as aluminium rivets for reduced corrosion. Three (3) stainless steel hose clamps are used to permit adjustment of the antenna on each band. Assembly is simple and straightforward, and if by chance something does go wrong most parts can be obtained from your local hardware store, e.g. nuts, screws, rivets, U bolts etc.
The Rippletech radial kit is recommended for tower or mast mounting of the antenna. Optional S/S mounting U bolts are also available instead of the zinc plated versions for an additional cost of $20.00 inclusive of GST.
The TZ-V-4 is supplied with all stainless steel hardware except for the boom/pole mount U bolts (optionally S/S).